Panasonic KX-NS500, Руководство по установке

Страница: 269 / 338

8.
Move the mouse pointer over System Property .
A menu will be shown under the mouse pointer.
9.
Click Site .
10.
Click the Port Number tab.
11.
Programme the following items according to the protocol used by KX-UT series SIP phones in the remote
site.
a.
When the KX-UT series SIP phones are using HTTPS:
•
CWMP (HTTPS) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTPS) Port No. for SIP-MLT
b.
When the KX-UT series SIP phones are using HTTP:
•
CWMP (HTTP) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTP) Port No. for SIP-MLT
Note
For the default port numbers of the PBX, refer to "8.6 Port Security".
12.
Click OK .
Using the PBX as an NTP server
When the PBX will be used as an NTP server, follow the procedures below.
1.
Click Setup
®
Network Service
®
Server Feature
®
NTP .
2.
Select Enable .
3.
Click OK .
Programming the router at the main site with Built-in Media Relay Gateway
Port forwarding settings (Router – PBX)
Configure the following items for port forwarding between the Media Relay Gateway and the router.
For the KX-NT500 series:
Application LAN Side Port Number WAN Side Port Number
PTAP Signalling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.15 PBX Configuration—[1-1]
Configuration—Slot—Card
Property—V-SIPEXT")
Signalling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.15 PBX Configuration—[1-1]
Configuration—Slot—Card
Property—V-SIPEXT")
MGCP Signalling (MGCP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.15 PBX Configuration—[1-1]
Configuration—Slot—Card
Property—V-SIPEXT")
NAT - MGCP Server Port No.
(Use the same value as in step 5 of
"Programming the PBX with Built-in
Media Relay Gateway".)
Installation Manual 269
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway