Panasonic KX-NS1000, Руководство по установке, Страница: 234 / 416

5.6.3 Programming the Network Settings
For successful operation of a VoIP network using the V-IPGW16 card, network settings for the PBX at each
location must be programmed appropriately. For a detailed discussion of related features, refer to the Feature
Guide.
This section details the procedure to programme the network settings for the local PBX. After the programming
for the local PBX has been done, repeat the procedure for the remote PBX with the appropriate setting values.
The following procedures describe the process of programming the network settings for each numbering
method.
Programming for the PBX Code Method
1. a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-IPGW16 .
c.
Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options, and
click
Ous (out of service) to set the card to out of
service.
d.
Repeat step c for each installed V-IPGW16 card until
all V-IPGW16 cards are OUS.
e.
Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options, and
click
Port Property .
Confirm that all V-IPGW16 cards are OUS.
Note
When a V-IPGW16 card is installed, 8 ports are
available for the card (a port has 2 channels).
2. a.
Click Setup
®
PBX Configuration
®
CO &
Incoming Call .
b.
Click CO Line Settings .
c.
Type the CO Name and assign an unused Trunk
Group Number to be used for all IP trunks.
d.
Click OK .
234 Installation Manual
5.6.3 Programming the Network Settings