document feeder. To return the document to it’s
original order you can feed it through the document
feeder a second time, see page 65.
R
Confirm that there are no documents on the scanner
glass.
R
Confirm that any ink, paste or correction fluid has
dried completely.
R
Remove clips, staples or other fasteners.
R
Do not insert the following types of documents (Make
a copy of the document using the scanner glass and
set the copy instead.):
– Chemically treated paper such as carbon or
carbonless duplicating paper
– Electrostatically charged paper
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
be seen through the other side, such as newsprint
R
When feeding multiple page documents into the
automatic document feeder, dirty marks may be
added to the original documents. To prevent this, we
recommend to feed documents one page at a time
when using the automatic document feeder, or to use
the scanner glass.
R
The total height of the documents when laid flat, must
be less than 2 mm. If the documents exceed the
capacity of the automatic document feeder, they may
fall or cause a jam in the feeder.
R
To set a document with a width of less than
210 mm, we recommend using the scanner glass to
copy the original document onto A4 or letter-size
paper, then setting the copied document for better
results.
R
Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
R
Available document size, document weight and
effective scanning area are as follows:
Minimum document size
128 mm
148 mm
Maximum document size
356 mm
216 mm
Effective scanning area
216 mm
208 mm
4 mm
4 mm
4 mm
4 mm
R
Shaded area will be scanned.
R
When using the unit as a scanner (page 28,
29), the effective scanning length depends on
the selected paper size.
Document weight
R
Single sheet:
60 g/m² to 75 g/m²
R
Multiple sheets:
60 g/m² to 75 g/m²
19
2. Preparation