Installation/Troubleshooting
52
2.6
IPv6
Problem
Cause and Remedy
The Top page is
not displayed
with the IPv6
address.
• The IPv6 address is not set on the camera.
Check if the IP address and default gateway are displayed in
the network (IPv6) column of the status page (see page 109
of Operating Instructions on the Setup CD-ROM). If neither
or only one is displayed, it is possible that the connection is
incorrect or that the IPv6 router is not set properly. Set them
correctly.
• The IPv6 has not been set up on your PC.
IPv6 is not set up in Windows XP when purchased. Change
the settings to enable it. (see page 14 of Operating
Instructions on the Setup CD-ROM)
• Router filtering is enabled.
Permit camera access from the WAN side in router settings.
• Your network or ISP may not support IPv6 at this time.
kxhcm280ait.book 52 ページ ２００５年３月９日 水曜日 午後１時２３分
