Installation/Troubleshooting
[For assistance, please call: 1-800-272-7033] 35
1.13.2 Mounting on the Ceiling
Mount the camera at an even place where vibrations etc. are few. Set the Tilt range
to
[On the ceiling]
on Camera Setup window (see page 65 of the Operating
Instructions on the Setup CD-ROM). Two ways of wiring can be considered; wiring
through a hole made in the ceiling or wiring without making a hole for a cable in the
ceiling. Select either one of the two.
Wiring through a hole made in the ceiling
1.
Fix the Ceiling Plate B on the ceiling with Screws B.
•
Fix the Ceiling Plate B more than 100 mm (4 inches) off the wall or other
obstacles from its center.
•
Make sure the camera is firmly mounted on a beam of wood etc. When
there is no beam, apply a board on the other side of the ceiling to make
sure the camera does not drop.
Screws B (4 pcs.)
Keep more than 100 mm
(4 inches) off the wall or
other obstacles.
Camera direction
100 mm
(4 inches)
kxhcm280ait.book 35 ページ ２００５年３月９日 水曜日 午後１時２３分
