Panasonic DMC-F3P, Руководство по обслуживанию

Страница: 37 / 47

37
8.4.6. USB STORAGE INFO. REGISTRATION
[ PREPARATION ]
1. Perform the “8.3 Execute the Adjustment software“DscCalDi.exe”” in advance.
[ SETUP ]
1. Click on “Get” button.
(The USB Strage data is displayed.)
2. Confirm that the following data is displayed in each frame.
If not, revise the data as follows.
* “VID” frame : “MATSHITA”
* “PID” frame : “DMC-F3” ----(For DMC-F3), “DMC-F4” ----(For DMC-F4).
* “Rev” frame : “1.00”
3. Change the data in “Serial” frame from “00000000000”(11 digit) into the serial number.
(The serial number (it consists of 11 digit) is printed on the nameplate which is putted on the bottom side of the Unit.)
NOTE:
To change the data, delete data first, then enter the data.
4. Click on “Set” button, which is located on just below the “Get” button.
[ AFTER SETTING-UP ]
1. Close the “DscCalDi.exe” by clicking on the “X” located on the top right corner.
The LCD of the Camera unit becomes black fade.
2. Turn “off” the power switch of the camera unit.
3. Disconnect the USB cable.