- 9 -
1.5 meter
(2) Electrical requirement.
The unit must be permanently connected to the Main Supply of AC230V 50 A.
(1) Make sure water flow presure.
Min. Water Pressure
44kPa / 0.45k
g
f/cm²
Max. Water Pressure
544kPa / 5.55k
g
f/cm²
• How to measure the water pressure.
Water should come out of the host 1.5m above the Power Selector Knob
as illustrated.
(3) Parts list.
Unit / Filter Knob / Rubber Packing (1) / Screws (4) / Wall Plug (4) / Manual / Post Card for warranty.
x 4
x 1
x 4
ELB CHECKER
RESET PUSH UP
ELB
POWER SELECTOR
SUPER POWER
MULTI POINT
ELB CHECKER
RESET PUSH UP
ELB
POWER SELECTOR
SUPER POWER
MULTI POINT
DH-10BM1P
THE UNIT MUST BE EARTHED.
裝置上必須連結接地線。
1. BEFORE YOU START INSTALLATION /
在你還沒有開始安裝之前
SPECIAL SKILL IS REQUIRED TO INSTALL THE UNIT. PLEASE ASK FOR THE AUTHORIZED PANASONIC DEALER.
必須以專門技術員來安裝。或向授權經銷商連絡委託裝置。
CAUTION :
Ensure the installation location (Example : On top of Roof, Ceiling, Confine Cabinet, Outdoor, etc) shall not lead to smoke
emission, ignition, fire, electric shock and damage to property in case of water leak.
Water leak could occur when Pressure Relief Device is activated, improper installation piping condition, etc.
Warning :
警告：
HOW TO INSTALL PANASONIC ELECTRIC WATER HEATER
PANASONIC
家庭用電熱噴水器的安裝法
(1)
確定水壓
最低水壓
44kPa / 0.45k
g
f/cm²
最高水壓
544kPa / 5.55k
g
f/cm²
•
確定水壓法。如圖表說明先將軟管連接到水龍頭後，
自來水騰到電量調整鈕
1.5m
高的另一端，即可使用。
(2)
電機規定
熱噴水器整體必須永固的連接在主要電源，
AC230V 50 A
。
(3)
零件目錄
機體 / 過濾器鈕 / 橡膠襯墊 / 螺絲(4) / 螺拴 (4) / 說明書 / 保修卡。
Unit
機體
Post Card for warranty
保修卡
Filter Knob
過濾器鈕
Rubber Packing (1 pcs)
橡膠襯墊
(1
個
)
Screws (4 pcs)
螺絲
(4
支
)
Wall Plug (4 pcs)
螺拴
(4
支
)
Manual
說明書
注意：
确保安装位置（例如：在屋頂之上，天花板，橱柜限制，户外等）不得導致黑烟，着火，火灾，触电和漏水導致建築物損壞。
當泄压装置被激活时漏水可能會发生，水管安装不当情况，等等。