ELB CHECKE
R
RESET P
USH UP
ELB
POWER SELECTOR
SUPER POWER
MULTI POINT
- 14 -
WARNING
In order to avoid a hazard due to inadvertent resetting of the thermal cut out,
this appliance must not be supplied through an external switching device,
such as timer or connected to a circuit that is regularly switched on and off
by the utility.
警告
為了避免因不慎按到重新設置熱能斷流器所造成的危險，
此花灑器禁止使用外加調節器，如定時器或連接至定時開關的電路。
WARNING
Do not switch on if the water in the unit became ice.
警告
當機體內的水結成冰時切勿啟動開關。
(3) • Open the Hot Water Faucet and set the power.
•
Set Power Selector Knob to LO,MED or HI.
When the ELB Lamp is light up, the hot water
will flow out.
(3) •
擰開熱水出口的水龍頭和置電量調整鈕。
•
置電量調整鈕設在
LO
，
MED
或
HI
。
使到
ELB
和電量指示燈發亮，跟著流出熱水。
(4) Regulate the Hot Water Faucet so that the hot water
temperature becomes optimum.
• Too hot
* Further open the Faucet.
* Check for clogging of the piping
• Too cold
* Reduce the volume of water
(4)
調旋水龍頭的活栓，使到噴水到達最佳的溫度。
•
噴水過熱
*
全開水龍頭。
*
檢查水管有無阻塞。
•
噴水過冷
*
擰閉水龍頭而縮小流量。
(1) • Turn on the Main Water Valve.
• Check if water leaks from the pipe line.
(1). •
擰開水道的主閥。
•
檢驗配管是否有漏水。
(2) • Before switch on electricity, check the wiring.
• Set the Miniature Circuit Breaker to “ON".
• Set the ELB of the unit to “ON" (Push up the
Reset Lever)
• Push the Test Button of the ELB Test Button.
• It is normal if the ELB turns “OFF" (the RESET
Lever falls) and set the ELB to “ON" again.
(2) •
在還沒有接通電流時，檢查接線。
•
將電流回路切斷器設在
“ON”
的位置。
•
將
ELB
的開關轉換於
“ON”
（將復原控制棒）。
•
按下
ELB
的檢查處的試驗電鈕。
•
如開關之即斷電，則為之正常狀態（復原控制棒落下）
跟著
ELB
回復
“ON”
的位置。
ELB Lamp
ELB
指示燈
Power Selector Knob
電量調整鈕
ELB Test Button
ELB
試驗鈕
Filter Knob
過濾器鈕
ELB RESET Lever (2pcs)
ELB
復原控制棒（兩個）
Main Water Valve
水道的主水閥
Hot Water Faucet
熱水水龍頭
5. TEST OPERATION /
試動