34
CY-VHD9500U
CY-VHD9500U
35
Installation
(continued)
E
N
G
L
I
S
H
15
E
N
G
L
I
S
H
16
3
Insert the bosses of the main unit underside in
the base plate guide holes.
4
Use a screwdriver to tighten the screws
(in 6 positions) that you previously tightened
loosely to secure fi rmly the main unit.
5
Insert the end of the panel, and push it
back into place as shown in the fi gure.
Secure the screws.
Note:
≥
Be careful not to scratch the surface of
the front cover when attaching it.
1
Connect the wires (page 36 to 39) which
were pulled out in a previous step to the unit
(page 30).
2
Bind the wires using the cord clamps (
=
) after
connecting.
Caution:
≥
Never to be hit by the screws or pinched
between the plates.
Caution:
≥
When connecting stripped wires,
be sure to wrap them securely with
electrical tape to prevent shorts.
Caution:
≥
If there is any extra wiring, push it
from the pull out opening to behind
the ceiling, taking care so that it is not
pinched between the main unit and
base plate. Failure to heed this caution
may result in an accident and/or injury.
5
Connect the wires and attach the main unit.
1
1
2
Where the wires emerge
in the front seat side
(at 2 positions)
Where the wires emerge
in the rear seat side
(at 1 position)
Push in any extra wire.
=
Cord clamp
a
2
=
Cord clamp
a
1
Bend the cord clamps about
1
/
4
q
(5 mm) from
their ends, pass the cord clamps through the
installation holes in the main unit’s rear panel,
and then use them to secure the wires. Finally,
cut off the excess parts of the cord clamps.
