30
CY-VHD9500U
CY-VHD9500U
31
Installation
(continued)
E
N
G
L
I
S
H
11
E
N
G
L
I
S
H
12
2
Put the headliner that was removed earlier back
in its original place.
3
In the re-attached headliner, locate the center
position of the base plate which has been
attached to the reinforcement crosspieces,
and cut out the section that will expose the
reference holes to view.
4
Align the guide holes in the accessory paper
template (
1
) with the reference holes which
can be seen from the section that was cut
out from the headliner, and paste the paper
template onto the headliner using a tape or
other thing.
Caution:
≥
As you cut the headliner, take care
not to cut your fi ngers. Also take care
not to damage any other areas of the
headliner. Failure to heed this caution
may result in an accident and/or injury.
Note:
≥
Some cars have a thick headliner, use
spacers or have other conditions that
prevent the use of blue ceiling refl ected
illumination. Before proceeding with the
installation, contact your dealer and fi nd
out whether your car allows the use of
refl ected light.
≥
Before cutting the headliner, check the
direction of the paper template to prevent
any mistakes in the installation position.
Headliner
Reference holes
1
Paper template
Cut out
Front side
Rear side
5
Pull out the wires that you pulled from the
pullout opening of the base plate beforehand so
that it will be easier to wire.
3
Wire the unit and replace the headliner.
1
Connect the wiring of the dome light and
the unit, and bring the wiring as far as the
installation position.
Caution:
≥
Pass the wiring you have brought to the
installation position through the pullout
openings in the base plate. Take care
that the wiring is not pinched or caught
by the top of the base plate.
Pullout openings
Base plate top
Note:
≥
The wiring method may vary depending
on the type of vehicle. Consult a service
technician as needed.
