Panasonic CS/CU-KU12ZKY Series, Руководство по эксплуатации и установке

Страница: 19 / 32

19
Indoor Unit Installation
For the right rear piping
For the right rear and right
bottom piping
•
•
Do not turn over the unit without it’s shock absorber during pull out the piping. It may cause intake grille damage.
Use shock absorber during pull out the piping to protect the intake grille from damage.
Intake grille
Piping
pull out th
e pip
ing
Piping
Shock absorber
pull ou
t the
pip
ing
Step-1 Pull out the Indoor piping
Step-2 Install the Indoor Unit
Step-3 Secure the Indoor Unit
Step-4
Insert the power supply cord and
connection cable
•
Insert the cables from bottom of the
unit through the control board hole until
terminal board area.
Step-1 Pull out the Indoor piping
Step-2 Install the Indoor Unit
Step-3
Insert the power supply cord and
connection cable
•
Insert the cables from bottom of the
unit through the control board hole until
terminal board area.
Step-4 Secure the Indoor Unit
For the Embedded Piping
Cover for the
bottom piping
Cover for the
bottom piping
Tape it with piping in a
position as mentioned
in Fig. below.
Cover for
the right
piping
Piping
Drain
hose
Cover for
the left
piping
Right Rear piping
Cover for piping
How to keep the cover
In case of the cover is cut, keep
the cover at the rear of chassis as
shown in the illustration for future
reinstallation.
(Left, right and 2 bottom covers for
piping.)
English
Installation instruction
Cover for
the bottom
piping
Tape it with piping in a
position as mentioned
in Fig. below.
Cover for
the right
piping
Piping
Drain hose
Cover for
the left
piping
Right and Right Bottom piping
Install the indoor unit
Hook the indoor unit onto the
upper portion of installation
plate. (Engage the indoor unit
with the upper edge of the
installation plate). Ensure the
hooks are properly seated
on the installation plate by
moving it in left and right.
Drain hose
Sleeve for
piping hole
Indoor unit
Hooks at
installation plate
Piping
Step-1 Replace the drain hose
Step-2 Bend the embedded piping
•
Use a spring bender or equivalent to bend
the piping so that the piping is not crushed.
Step-3
Pull the connection cable into Indoor
Unit
•
The power supply cord and indoor unit
and outdoor unit connection cable can be
connected without removing the front grille.
Secure the Indoor Unit
Press the lower left and right
side of the unit against the
installation plate until hooks
engages with their slot (sound
click).
Installation
plate
Unit’s hook