Panametrics Sentinel LCT, Руководство пользователя

Страница: 51 / 248

Sentinel LNG User’s Manual 39
Chapter 3. General Programming
3.3 Program Menu Options
3.3.1 Channel Program
For the Channel Program setup, refer to the appropriate section for a discussion of the following PROG menu options,
beginning on page 43.
•
Status - activate or deactivate the channels/paths.
• Fluid - enter Reynolds Correction data (not supported at this time).
• Signal - enter the zero cutoff parameter.
• Error Limits - enter minimum and maximum signal, velocity, amplitude and soundspeed.
3.3.2 Composite Program
For the composite program setup, refer to the appropriate section for a discussion of the following Composite menu
options, beginning on page 47.
•
Fluid - enter fluid type in normal or Tracking Windows Mode.
• Signal - enter the number of errors allowed and the Compensation Status (additional option).
• Inputs - enter the temperature, pressure and density parameters.
• API Setup (additional option) - enter the table type and conditions.
3.3.3 Advanced Program
Note: The Advanced Program is accessible only to persons with Field Service, Factory or Engineering status.
For the advanced program setup, refer to Chapter 4, Advanced Programming .
• Transducer - enter data for preprogrammed or special clamp-on transducers
• K Factor - enter the Meter Correction (K) Factor as a single value or as a table of values
• Pipe - enter pipe parameters
• Weight Factors - enter the appropriate weight parameter.
To measure flow rate with the Sentinel LNG , activate the channel/path(s) and enter the transducer, pipe and fluid
parameters. Appendix A includes a complete set of menu maps for the User Program, including Figure 231 on
page 212 for the PROG menu.
Note: This manual describes the programming of Channel 1, only. To program Channels 2 through 4, simply repeat
the same procedures presented for Channel 1.