Panametrics DigitalFlow GC868, Руководство по программированию, Страница: 74 / 134

Chapter 4. Printing Data
4-9 DigitalFlow™ GC868 Programming Manual (2-Channel)
Note:
The printouts generated from the
CROSS
and
BOTH
submenus will appear
after the
SIGNL
printout, as separate listings.
The data printed in this array permits a comparison of the relative signal strengths of
the upstream and downstream transducers, which are used to calculate a single
flow measurement.
4.8 Printing RTD
Data
Use the RTDs submenu to send the numeric point value of a connected RTD device to
the RS232 port for display on a terminal or RS232 printer. By viewing the point value of
the meter at a given temperature, you can calculate the points at the Set
Temperature, and the slope of the RTD input in points/degree. (See Chapter 1,
Calibration , of the Service Manual for more details.)
1. To access the
Print Menu
, press the [PRNT] key.
Note:
The
Print Menu
is not protected by the security feature and a password is
never required to access this menu.
2. Press the [
←
] or [
→
] key to display the option bar shown, and then press [F3] to
select the RTDs submenu.
3. At the Dump RTD Data prompt, press [F1] to leave the PRINT menu without
dumping data, or [F2] to send the RTD data to the RS232 port.
After the selection has been made, the Model GC868 returns to the standard data
display screen and normal measurement taking. If you have selected YES at the
DUMP RTD DATA prompt, the meter continues to send data until you reenter the
PRINT menu and select the STOP option.