Pall Stax, Инструкция по эксплуатации

Страница: 8 / 16

When processing flammable fluids, the user should ensure that any air is fully purged from
within the assembly during filling and subsequent operation to prevent the formation of a
potentially flammable or explosive vapor/air mixture inside the equipment. This can be achieved
through careful venting of the assembly or system as detailed in the user instructions.
To prevent damage or degradation which may result in leakage of fluids from this equipment it
is imperative that the end user check the suitability of all materials of construction (including
seals on the connections where appropriate) with the process fluid and conditions. The user
should ensure that the assembly is regularly inspected for damage and leaks, which should be
promptly corrected, and that seals (where appropriate) are renewed after every capsule
change.
Leakage of flammable or reactive fluids from this assembly, arising through incorrect installation
or damage to the equipment (including any seals), may generate a source of ignition if
flammable fluids are exposed to a heated surface, or if reactive fluids contact incompatible
materials that may lead to reactions generating heat, flame or that are otherwise undesirable.
The user should ensure that the assembly is regularly inspected for damage and leaks, which
should be promptly corrected, and that any seals are renewed after every filter change. The
user should ensure that these products are protected from foreseeable mechanical damage
that might cause such leakage, including impact and abrasion. Should you have any questions,
please contact your local Pall office or distributor.
Appendix A: Chassis User Instructions — Pilot Scale
1. Pilot Scale Chassis Components Front View
Item Description Quantity
1 Torque Wheel and Limiter 1
2 Clamping Spindle 1
3 Cross Beam 1
4 Support Leg 2
5 Capstan Nuts 2
6 Clamping Plate 1
7 Rear Location Post 1
8 Cap Screw 1
9 Base Plate 1
2. Pilot Scale Chassis Assembly
To mount support legs:
1. Insert support legs through holes in base plate.
2. Attach capstan nuts to screw threads at end of
support legs.
3. Tighten capstan nuts by hand counterclockwise to
secure support legs to base plate.
4. Insert location post through the appropriate hole in
base plate.
5. Insert cap screw up into threaded hole in location post.
6. Tighten cap screw counterclockwise with appropriate
sized Allen Key.
8
USD 2554c
1
2
3
4
5
6
7
8
9
216495 - Pall Europe Ltd GN12.5291.qxd:Layout 1 1/6/12 14:10 Page 8