Pall Stax, Инструкция по эксплуатации

Страница: 11 / 16

4. Fitment of Bottom Manifold
1. Position the manifold on the base plate with the rear tab
below the cross pin and the side tabs against the
support legs.
2. Push the manifold down flat onto the base plate.
11
USD 2554c www.pall.com/biopharm
5. Placement of the First Filter Capsule
1. Center the capsule above the manifold with side tabs
latched around the support legs.
2. Push the capsule down firmly onto the manifold.
3. Check the position of the gasket. It must lie flat fully
within the recess in preparation for the next capsule.
6. Placement of Additional Filter Capsules.
1. Place the capsule into position slightly above the
previous capsule ensuring side tabs latch around
support legs.
2. Push the capsule down on top of the filter capsule
below.
3. Check the position of the gasket. It must lie flat fully
within the recess.
4. Repeat steps 1 to 3 for required number of capsules:
for the 5-high chassis, a maximum of 5 large capsules,
and for the 10-high chassis, a maximum of 10 large
capsules.
7. Bottom In/Bottom Out Flow Version
1. Clip the vent manifold onto the support bars and push
down onto top capsule.
2. Rotate torque wheel clockwise to clamp down capsules
until torque limiter clicks out and wheel rotates freely.
Check to ensure that capsules are fully clamped down.
3. Connect inlet and outlet lines to the bottom manifold as
indicated by the flow arrows on the manifold.
4. Open vent valves by rotating them counterclockwise.
5. Begin slowly filling capsules until fluid appears from
the valves.
6. Close vent valves by rotating them clockwise.
7. Check for leaks.
216495 - Pall Europe Ltd GN12.5291.qxd:Layout 1 1/6/12 14:10 Page 11