PALAZZANI RAGNO XTJ 32 / C, Руководство по эксплуатации и обслуживанию

Страница: 123 / 210

Palazzani
Palazzani Industrie spa
OM 601 pag 6 Cap 6
6.5. QUARTERLY CHECK
The quarterly check must be done when the machine is clean and has to be
registered. The operator is recommended to wear gloves, glasses, proper clothes
and to have his hair protected.
Pay attention when using compressed air or water under high pressure and check
no other people are in that area; it is better that only one person make the ordinary
check. If the work has not been completed, leave a sign on the machine in order
not to allow its usage.
When opening the hoods from the engine, the batteries and the hydraulic main
circuit, be aware of this:
•
The noise levels are changed and it is recommended to wear acoustic
protections
•
The batteries are not covered and so it is recommended not to allow flames or
fires near them. It is also recommended to wear glasses
•
The temperature in some parts may overcome the ordinary level, thus it is
recommended not to touch any part without gloves
It is recommended to execute these operations:
•
Check the inspection register to verify the completeness of the previous
maintenance operations
•
Daily execute all the maintenance operations.
•
Grease the telescopic extensions of the arms using a brush
•
lubricate chain for the boom extension with a brush (see paragraph 6.12
“maintenance”
•
Check the state of the oil in the tank: it must be coloured in light yellow; it must
not present foam or look milky because of the presence of water
•
Verify the absence of oil leaks or damage to flexible pipes in the articulations of
the arms or inside the frame (lift the machine on the stabilizers and look
beneath the frame
•
Check the oil levels and the amount of hours the thermal engine has been
running; therefore execute all the maintenance operations or the needed
replacements. Clean the edge of the caps in order not to let powder in
•
Check the level of the electrolyte in the batteries
•
Inspect the arms next to the pivots or the sliding pads, in order to verify the
absence of damages in the joins, maybe caused by crashes or by unusual
vibrations
•
Put the tracks under tension using the greasing pump (see previous chapter)