Section 5
LABELING UNIT
-
8
-
English
F
412
0501
00.fm
ID
M
version:
Module 40/60/90/120
Important
To attach labels to rotating bottles,
reduce the primary diameter of the
gear to suit the ratio of the bottle’s
actual peripheral speed to the
peripheral speed of the plate center.
Important
While tightening the M8 fixing
screw, turn the encoder unit towards
the carousel gear so as to take up
any slack between the carousel gear
and the gear wheel SK-0130-A. The
lack of slack guarantees a greater
precision in the delivery of the label.
ELECTRICAL CONNECTIONS
Important
Since the labelling unit is not an
autonomous machine, but rather a
unit meant for integration with an
equipment built by third parties, the
installer shall foreseen and install a
disconnecting switch and an
external emergency-stop circuit on
the electric system of the machine
including the unit. Such devices
shall comply with the EN 60204-1
regulation.
– Using the special tools for the
purpose, make sure that the earth
system of the plant and the power
supply line to which the machine will be connected are
perfectly efficient.
– The unit shall be connected to a single-phase power
feeding: check that the line voltage (V) and the
frequency (Hz) correspond to the data shown on the
identification plate.
– Power supply connection shall consist in connecting
the earth wire to the terminal marked with the letters
“PE” and the two phase wires to the terminals marked
with “L1” and “L2” inside the switchboard. Please, see
the electric documentation attached for any further
information about power supply connection.
Important
If the connection is made incorrectly, disconnect the
voltage and consult the electric diagram of the
general electric system.
IDM-01_010_0.tif
labelling gear
screw
spacer
gear
(SK-0130-A)
washer
M8
hole
IDM-01_011_0.tif
