PACiS GTW GTW/EN T/C40, Техническое руководство

Страница: 201 / 298

Maintenance GTW/EN MF/C40
PACiS GTW gateway Page
13
/68
Defines a timeout ( in seconds) of communication with
SCADA. After this delay if the SCADA don't send any
request. It's considered as disconnected. The PACiS GTW
stop memorising AI without time-stamp in its database. "delai_mesures_non_datees" dword 0 s 0 s 1200 s Y
In case of lost of communication this permit to avoid
saturation of event stack.
Maximum delay (in milliseconds) between two characters in
a fixed length frame (Frame starting with 0x10, Class1
request for example). "Delay_After_1st_Byte_Fixed_Msg" dword 0 ms 0 ms 1000 ms Y
This can be increased in case of trouble on communications
link (value 100).
Maximum delay (in milliseconds) between two characters in
a variable length frame (Frame starting with 0x68, request of
general interrogation for example). "Delay_After_1st_Byte_Var_Msg" dword 0 ms 0 ms 1000 ms Y
This can be increased in case of trouble on communications
link (value 100).
"di_lost_events" dword 0 0 0xFFFFFF Y In case of communication lost with SCADA. If the loose of
communication is too long, the circular stack for recording
event could be saturated. In this case, old events are lost.
When communication is available the PACiS GTW indicates
the lost of old event by a special DI. This key define the
T101 address of the DI to send to SCADA. If this key is 0 no
DI will be sent
Indicates that during a GI we want to upload events
0: Possibility to receive events during a GI.
"EndGIBeforeEvent" dword 0 0 1 Y
1: Receiving events during a GI is inhibited.
'Activation termination' message during an DO sequence.
According to the T101 standard, the Activation Termination
is not mandatory.
01: 'Activation termination' is sent,
"Flag_Act_Term_TC" dword 1 0 1 Y
00: 'Activation termination' is not sent.