PACiS GTW GTW/EN T/C40, Техническое руководство

Страница: 20 / 298

GTW/EN TD/C40 Technical Data
Page 4/14
PACiS GTW gateway
2. INDUSTRIAL PC CHARACTERISTICS
2.1 Operating System
Gateway software is intended to run under an industrial PC running under Windows
2000Pro, Windows 2000 Server or Windows XP operating system with at least 256 Mo of
RAM.
Using 256 Mo of RAM you will not needed to have a swap memory i.e. the gateway and the
system will run in RAM.
2.2 Configuration
The configuration of the gateway is given in table 1 of chapter GTW/EN HW/C12. This
configuration complies with the environmental constraints given hereafter.
2.3 Communication ports with SCADA
•
Number of simultaneous protocols: 4
•
Number of serial ports by protocol: 2 (main, redundant)
•
Thus 8 ports maximum on one gateway: 2 cards with 4 ports
•
Number of communication port settable by PACiS SCE: 8
•
Baud rate (bits/s): from 300 to 19200 settable by PACiS SCE
In the industrial PC configuration described below the motherboard has two serial
communication ports. You can use them for one communication with SCADA plus a
redundant port or two communications with SCADA. For additional communication ports you
will need to add a PCI or an ISA communication card into the PC.
2.4 Ethernet Communication port
The Ethernet communication port is a 10 / 100 Mbps RJ45 connector.
2.5 Rated Values
TEST
INTERNATIONAL
STANDARD
Harmonised
Rated Auxiliary Voltage
DC IEC 60255-6 Minimum requirement
48 VDC, 110/125 VDC, 220/250 VDC
Rated Frequency IEC 60255-6 50 or 60 Hz.
Rated AC Voltage No Standard 84 à 240 VAC