Pacbrake is a registered trademark of Pacbrake Co.
8
HP10216 AMP AIR SUSPENSION KIT
L6360
ECN 1-1789
L6360_Rev4_17.07.2018
6
LOWER BRACKET INSTALLATION
Push the lower bracket (D) forward or back to center it over the
jounce bumper strike plate. Insert a Hex Head Bolt (F6) through a
Flat Washer (F4) and J-clamp (E). Install the J-clamp with the short
end under the Jounce Bumper Strike Plate with the bolt through the
lower bracket. Cap with a Flat Washer (F4) and Nylon Locknut (F7).
Do this on the front and rear of the lower bracket and evenly torque
both sides to 10 ft-lbs keeping the lower bracket centered over the
jounce bumper strike plate on the axle. Repeat on the other side.
NOTE:
It may be necessary on some models to slightly pull down the
hard brake line on the rear right (passenger side) in order to install
the lower bracket mounting hardware.
7
EMERGENCY BRAKE CABLE MODIFICATIONS
• It will be necessary to re-locate the emergency brake cable that is
held by a bracket on the top of the axle center carrier section of the
rear end.
• Remove the top bolt that is holding the emergency brake cable
bracket onto the center section of the rear end.
• Remove the bracket from the emergency brake cable and
discard it.
• Install the large cable clamp over the emergency brake cable facing
the rear with the hole down and attach to the rear end using the
stock bolt previously removed.
• Bend the large cable clamp slightly to obtain clearance of the hard
brake lines. Mounted on top of the axle.
• Insert the emergency brake cable into the large cable clamp.
6A
7A
7C
7B
