Pacbrake is a registered trademark of Pacbrake Co.
6
HP10216 AMP AIR SUSPENSION KIT
L6360
ECN 1-1789
L6360_Rev4_17.07.2018
5A
5
INSTALLING THE AIR SPRING ASSEMBLIES
• Install a large flat washer (F3) over the hex head bolt (F2) and
thread the bolt onto the supplied wire to create a leader tool.
• Insert the bolt and washer through the slot on the side of the frame
and through the slot on the bottom of the frame where the ABS line
holder was removed. Repeat on the other side.
NOTE:
The fittings on both air springs will be facing inboard.
• While raising the assembly, line up the bolt previously installed with
the back hole on the bracket. Set the new ABS line holder over the
bolt once the upper bracket is in place and cap with a flat washer
(F4) and nylon locknut (F7). Leave loose at this time.
There are two ways to attach the front side of the upper bracket
depending on whether you have a 5th wheel bracket running
alongside of the frame or not.
FOR VEHICLES WITHOUT A 5TH WHEEL BRACKET ALONG
THE SIDE OF THE FRAME:
• Set the U-bolt (F8) over the frame and through the holes in the
upper bracket forward of the axle.
CAUTION:
DO NOT PINCH THE LINES ON THE LEFT (DRIVER)
SIDE FRAME RAIL.
• Cap with flat washers (F4) and nylon locknut (F7). Position the front
upper bracket onto the frame rail so the center hole is in the middle
of the frame and there is sufficient clearance between the fitting
and the stock jounce bumper cup.
• Torque the U-bolts to 10 ft-lbs. Repeat on the other side.
5B
5D
5C
