Pacbrake is a registered trademark of Pacbrake Co.
10
HP10216 AMP AIR SUSPENSION KIT
L6360
ECN 1-1789
L6360_Rev4_17.07.2018
9A
• Push the inflation valve through the hole, install
a flat washer, and another
5
⁄
16
"
nut to secure
it in place. Tighten the nuts to secure the
assembly.
• Route the air line along the frame to the air
fitting on the air spring. Keep AT LEAST 6" of
clearance between the air line and any heat
sources, such as the exhaust pipes, muffler,
or catalytic converter. Avoid sharp bends and
edges. Use the plastic tie straps to secure the
air line to fixed (non-moving) points along the
chassis. Be sure that the tie straps are tight,
but do not pinch the air line. Leave at least 2"
of slack to allow for any movement that might
pull on the air line.
NOTE:
Tie off the hose to the front hole of
the upper bracket or U-bolt, depending on the
mounting, with a tie strap to keep the hose away
from the exhaust.
• Cut off the air line, leaving approximately 12"
of extra air line. A clean square cut will ensure
against leaks. Insert the air line into the air
fitting. This is a push-to-connect fitting. Simply
push the air line into the swivel fitting until it
bottoms out (
9
⁄
16
"
of air line should be in the
fitting).
9
INSTALL THE HEAT SHIELD
• Bend the tabs on the heat shield (F15) so there will be the
necessary ½" dead space between the heat shield and the exhaust
pipe when the heat shield is attached.
• Attach the heat shield (F15) to the exhaust pipe on the passenger
side using two hose clamps (F16 / F17). Each hose clamp holds a
tab against the exhaust pipe. Make sure the heat shield is facing
toward the air spring.
NOTE:
The small worm gear clamps (F16) are intended to be used
with an exhaust that is between 2.5 - 4.5" in diameter. The larger
worm gear clamps (F17) are intended to be used with an exhaust that
is between 4.5 - 6.5" in diameter.
AIRLINE
(OPTION 1)
AIRLINE
(OPTION 2)
8B
