Ozito X PXC PXGMTK-4182, Инструкция по эксплуатации

Страница: 14 / 40

Tooth cutting direction.
a
b
a
Tooth cutting direction.
a
b
a
Tooth cutting direction.
a
b
a
Tooth cutting direction.
a
b
a
Tooth cutting direction.
a
b
a
14
4. CHAIN & BAR
Fitting the Guide Bar & Chain
1. Using supplied multi-tool 13/4mm remove the chain
sprocket cover bolt then
remove chain sprocket
cover.
2. Place the chain in the groove of the guide bar as
shown. Refer to the label on guide bar and chain
sprocket cover that indicates the direction that the
chain should face.
WARNING! ALWAYS WEAR GLOVES WHEN HANDLING THE CHAIN AS
IT IS VERY SHARP AND CAN CUT YOU WHEN IT IS NOT MOVING.
SETUP & PREPARATION
SETUP & PREPARATION (cont.)
WARNING! IF THE CHAIN IS INSTALLED BACKWARDS (CHAIN
CUTTERS ARE FACING IN THE OPPOSITE DIRECTION OF ROTATION) THE
POLE PRUNER WILL VIBRATE EXCESSIVELY AND NOT CUT.
3. Place the guide bar and chain onto the mount,
ensuring that the chain tensioning pin (a) sits
within the lower hole on the guide bar.
WARNING! ENSURE THE TOOL IS OFF AND THE BATTERIES REMOVED
BEFORE PERFORMING ANY OF THE FOLLOWING OPERATIONS.
4. Adjust the chain tensioning screw (b) with the multi-tool
until the chain tension pin (a) fits into the hole in the guide
bar, whilst guiding the chain around the sprocket.