5. TROUBLESHOOTING
DESCRIPTION OF SYMBOLS
Wear eye, ear & breathing
protection
Megapascals
Warning
Regulatory Compliance Mark
(RCM)
V
Volts
Hz
W
Hertz
~
psi
MPa
L/min
Alternating Current
Watts
Pound per square inch
Litres per minute
Read Instruction Manual
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
Symptom
Possible Cause
Suggested Solution
Little or no
material flow
Nozzle clogged
Follow instructions in
the Cleaning Manual for
cleaning the spray tip
Suction tube clogged
Clean
Pressure control dial
turned too low
Increase pressure
control dial setting
Suction tube loose
Insert & tighten the
hose clamp
Inlet filter clogged
Clean or replace
Material
leaking
Nozzle loose
Tighten
Nozzle worn
Replace
Nozzle seal worn
Replace
Material build-up on air
cap & nozzle
Clean
Atomisation is
too coarse
Larger tip & filter
required
Refer to spray tip
selection chart
Material volume too large Decrease pressure
control dial setting
Nozzle clogged
Clean
Inlet filter clogged
Clean or replace
Pattern runs or
sags
Applying too much
material
Adjust pressure
control dial or increase
movement speed of
spray gun
Too much
overspray
Gun too far from spray
object
Reduce distance
Too much material
applied
Decrease pressure
control dial setting
Pattern is very
light & splotchy
Moving the spray gun
too fast
Adjust pressure control
dial or decrease
movement speed of
spray gun
Spluttering
paint
Air bubbles in the return
pipe
Follow priming
instructions to remove
air bubbles
Inlet hose not
sucking up
water when
cleaning the
unit
Lack of pressure
Follow priming
instructions to re-prime
the unit
Machine not
priming
Spray gun tip is clogged Clean spray gun tip
Spray gun filter is
clogged
Clean spray gun filter
Priming lever is not set
to prime
Set priming lever to
prime
Paint outlet & inlet are
clogged
Clean paint outlet & inlet
Pressure too low
Set pressure control dial
higher
Inlet filter is clogged
Clean inlet filter
Paint station
is starting
& stopping
automatically
This is normal; this
ensures the correct
operating pressure is
maintained
No issue
Power tools that are no longer usable should not be
disposed of with household waste but in an environmentally
friendly way. Please recycle where facilities exist. Check
with your local council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in
the environment. Please recycle packaging where facilities
exist. Check with your local council authority for recycling
advice.
CARING FOR THE ENVIRONMENT
Содержание ASG-7000
Страница 24: ......