Priming The Pump
The airless sprayer needs to be primed every time a spray material is
used. Whether you are setting the machine up for use after cleaning/
storage, changing paint colours, or swapping from a stain to varnish,
you will need to follow the priming procedure for the pump and spray
gun.
Note:
When changing between different paint colours, it is
recommended to clean the sprayer to prevent paint mixing and for
best results.
1. Fully submerge the inlet filter in the spray
material.
2. To prevent any lubricants or impurities
getting into your spray material, hold
the return pipe over a waste bucket and
continue with the priming steps.
When spray material starts coming out of
the return pipe, submerge the return pipe
in the spray material tin/bucket with the
inlet hose.
2. Set the priming lever to the prime position.
3. Adjust the pressure dial to the maximum
position by rotating it clockwise.
4. Switch on the unit and let the paint cycle
through the system for a few minutes.
5. Wait for any air bubbles to
clear the return pipe (this is
indicated by a steady stream
of paint out of return pipe)
then switch off the unit.
Priming The Spray Gun & High Pressure Hose
1. Remove the tip guard and spray
tip from the spray gun.
2. Set the priming lever to the spray
position.
3. Point the spray gun nozzle into a waste
bucket, then press and hold the trigger to
relieve the pressure in the line.
4. While still holding down the trigger, switch
on the unit.
5. Keep holding down the trigger until spray material is emitted from
the spray gun, at which point direct the spray gun back into the
spray material tin for a few seconds. Release the spray gun trigger.
8.
Switchofftheunit.
9. Re-assemble the spray tip
and tip guard. The sprayer is
now ready to use.
Note:
The motor automatically shuts off once the operating pressure
is reached and will start-up again when it drops below the cut-in
pressure. This is part of normal operation and does not indicate a
fault with the machine.
PRESSURE
CONTROL
PRIME
SPRAY
WASTE
Содержание ASG-7000
Страница 24: ......