Overland Data DLT LoaderXpress, Инструкция по установке и эксплуатации, Страница: 65 / 78

DLT LoaderXpress™ 5-1
'LETXIV8VSYFPIWLSSXMRK
(MEKRSWMRK4VSFPIQW
There are two main types of problems that can cause the LoaderXpress to malfunction or
fail to perform correctly: platform problems and general drive errors. Some errors cause
Fault Symptom Codes (FSC) to display on the control panel, along with a description of
the fault. Error Recovery Procedures (ERP) are available for each FSC. They are
described in this chapter.
4PEXJSVQ4VSFPIQW
These errors arise out of incorrect installation and configuration. The most common
characteristic of this type of error is that the LoaderXpress appears to operate normally,
except that no data can be interchanged. You may not get an error code on the control
panel. To identify an error as this type of problem, check your installation and
configuration setup, referring back to
Chapter 2 - Installation .
+IRIVEP(VMZI)VVSVW
These errors usually result from a miscommunication between the controller and the drive
processor or involve a mechanical malfunction. In most cases, these types of errors report
an error message and an FSC to the control panel. The only exceptions are power supply
problems and display malfunctions. The FSC can be used to determine a recovery
procedure.
Some error messages can be cleared by pressing
Enter
on the control panel, others by
cycling the power to the module. Often the module will resume normal operation. Other
errors are repeated when the operation is attempted again. Such recurrent errors may
require more extensive recovery procedures such as replacement of a part.
To aid you in localizing persistent errors, there are user diagnostics available on the Demo
Submenu. These are described at the end of this chapter.