Output Technology LaserMatrix Floor Model Stacker, Руководство оператора

Страница: 23 / 32

LaserMatrix Floor Model Stacker 21
3. Check that the four coils are at the bottom of their risers.
The top caps of the risers
contain two plastic barbs to
capture the coils and suspend
them so that you can easily
remove the print job.
NOTE: Make sure to lower
coils again after every print job
so that they’re ready for the
next print job.
LB0-N
4. Open bail of paper chute.
5. Make sure that the paper will stack on the stacker in the
same way it is in the box. To do this, mark an “X” on one
of the horizontal out-fold perfs at the paper entrance to the
printer, as shown in the following “Before” illustration,
and then use the printer’s control panel to form feed that
fold through the printer.