Output Technology LaserMatrix Floor Model Stacker, Руководство оператора

Страница: 13 / 32

LaserMatrix Floor Model Stacker 11
LB0-F2
c. Slowly open top cover of printer to check that this
paper chute assembly is securely in place.
10. See Caution and Note below before installing control
cable, as follows:
! CAUTION !
Do not use a control cable if your printer requires a
paper motion sensor for automatic operation. (See the
table on Page 29.) If you use a control cable where the
table on Page 29 specifies a paper motion sensor, you
may damage printer electronics.
NOTE: Two types of control cables are provided with the
stacker for use with LaserMatrix printers built after May
23, 1994. With all other printers, use either the manual
mode switch, shown in the illustration on Page 13, or
install a paper motion sensor (Part No. LM1000A119).
The paper motion sensor, like the control cables provided,
turns on the stacker only when the printer prints. For