OUMAN EH-201/L
OUMAN EH-201/L
INSTALLATION AND MAINTENANCE GUIDE
(standard factory delivery)
EH-201/L is fastened to its mounting base with three
screws (two mounting points under the cover in the
connection space and one in the installation bracket.
Cables can be brought for the regulator from above
(standard factory delivery) or from below. In addition, there
are 6 cable through-holes in the bottom of the regulator
case which can be opened, e.g., with a screw driver. Then
the cables can be brought into the connection space
through the bottom.
(turn the keyboard/display unit)
The cables can be routed between the
regulator and installation base when
spacers are used to mount the
regulator.
Remove the clear cover. Press
as illustrated in the picture and
pull the cover out of place.
Detach the keyboard / display
unit carefully by prying it with
a screwdriver.
Turn the keyboard / display unit
into the opposite position.
Press the keyboard / display unit
carefully into place.
Complete installation by pressing the
plastic plugs into the screw holes.
Switch off the voltage from the regul.
Press the fuse socket and turn it counter
clockwise. Change the 160mA (5x20mm)
glass tube fuse. Press and turn the fuse
socket clockwise into place.
EH-201/L has a backup that saves the
time and time program in case of a
short power failure. If the time is not
correct after the power failure, the
battery must be changed. Battery type:
Lithium button battery CR 1220, 3V.
Unfasten the regulator's fuse (see the
topmost picture). Carefully pry the old
battery from its holder, for eg., with a thin
screw driver. Push the new battery into
the holder with the + end up. The old
battery can be put into the garbage.
Changing the fuse:
Changing the cabling direction:
Spacers:
Plugs:
Mounting guide:
Screw the regulator to the wall using the installation bracket. Position
the unit so it is level. Screw the regulator firmly into place using two
screws through the connection space.
Installation bracket
If you want to bring the cables to the regulator from below, you
must turn the keyboard / display unit according to the following
instructions.
Cabling from above:
Cabling from below:
Changing the battery:
40