OUMAN EH-201/L
NET MEASUREMENT
OUMAN EH-201/L
Directions for entering the
maintenance mode are on page 21.
Net measurement
Outdr tmp meas
H1 Room meas.
Wind measure
Sun measure
DH Energy MWh
Watr consm.m3
OK.
OK.
Setting limits:
-
+
Press
Press the
or
button to set the limit and
confirm by pressing
Comp/Meas. data
min/
m/s
max/
m/s
0.0
10.0
Comp/ Meas. data
min/
lx
max/
lx
0
9000
By using the
button to browse, you can see which measurements can
be read from the net.
Move the cursor to the measurement you want
and press
If you want to select an serial interface for the
measurement in question, move the cursor to Yes
net and press
The
character indicates
that the measurement information is read from
the net.
OK
OK
.
.
Browsing the net measurements:
You must set the compensation limits for wind and sun
measurements. The minimum indicates when compensation begins and
the maximum indicates when compensation is at a maximum value.
Set the limits for wind measurement as wind speed (m/s) and for sun
measurement as amount of light (lx).
Outdr tmp meas
No net
Yes net
Setting net measurements:
Setting wind or sun measurements (net):
Attention! Set wind and sun compensation in "Settings" (see page 6-7).
Special mainten.
Rstore settings
Settings
Meas. 3 setting
Dig1 selection
Dig2 selection
LON initializ.
Net measurement
TextMessageSett.
Press the
button to move the cursor to
.
Press
"Net measurement”
OK
.
Ouman EH-201/L has an LON-200, EH-485 and
MODBUS-200 adapter card (optional equipment).
In this special
maintenance mode you can select which measurement information is
to be read from the net.
If you selected to read wind or sun measurements from the net,
you must set the compensation area in this mode.
ESC - press to return to the previous display
Info button - gives operating instructions
Browse button - moves the cursor up and down
ESC
Group select button - not in use in EH201/L
36
