Otto Bock C1000 DS, Инструкция по эксплуатации

Страница: 10 / 124

10
WARNING
Hazards while working on the wheel lock system.
Any repairs and adjustments to the wheel lock
may only be made by personnel authorised by Otto Bock. Incorrect settings can lead to brake failure
and therefore to serious bodily injuries and even death.
Note that there is no braking functionality when the wheel lock is unlocked. The wheel lock must only
be unlocked in hazardous situations and for maintenance or repairs. The corresponding force required
for acceleration and deceleration must come solely from the person pushing.
Once push mode is no longer needed, the wheel lock release lever must be locked immediately.
CAUTION
Risk of crushing or pinching in the pivot range of the footrests.
Ensure limbs are clear of the danger
zone when folding the footrests up or down.
CAUTION
Risk of accidents due to unsecured screw connections.
When screw connections with thread locks
are loosened, they must be equipped with new thread locks or secured with a medium-strength liquid
thread lock substance (e.g. Loctite 241).
After the power wheelchair has been set and adjusted, the attachment screws and/or nuts must be
firmly retightened. Observe the applicable torque specifications.
NOTICE
Risk of damage due to improper preparation of maintenance tasks.
• Before completing any maintenance tasks, turn off the power wheelchair and remove the fuse. This
does not apply to functional tests of the electrical components.
• Secure the product to prevent it from tipping over or falling.
• Some components of the power wheelchair, e.g. the batteries, frame, seat and motors, are very
heavy. Observe ergonomically correct practices when lifting these components or use sufficient hoist-
ing equipment.
• Clean / disinfect the product before you start the inspection. Consult the instructions for use regard-
ing product care or product-specific inspection information.
NOTICE
Risk of damage due to improper use of the seat adjustment functions.
The power wheelchair may
be equipped with seat height adjustment fixture, electric back angle adjustment and electric seat tilt
functions. The following particularities must be observed during operation:
• The seat function actuators are not intended for continuous use but only for short-term limited opera-
tion (10 % use, 90 % idle time). General recommendation: At maximum load capacity, 10 seconds of
operation should be followed by 90 seconds of idle time. The electric seat functions are considered
independently of the driving function for this purpose.
• The seat with seat height adjustment has a maximum load capacity of 130 kg or 200 kg.
• The seat height adjustment function may not be operated in case of errors or malfunctions.
• If creep speed is not automatically activated when the seat height adjustment function is operated,
an error has occurred. Any such errors must be promptly corrected by personnel authorised and
trained by Otto Bock. The power wheelchair may only be used with the seat in its lowest position
until the problem is corrected.