Parts List & Operating Instructions
511535 (6468) Ford Camshaft Pulley Holding Tool
Application: 1993 – 1997 Ford Probe w/ 2.0L, 4 cyl., engine
1. Rotate engine to align camshaft
timing marks with crankshaft
timing marks.
2. Insert No. 6468 (511535)
between intake and exhaust cam
pulleys. The tool will fit correctly
only one way. The side of tool
marked UP must be facing the
technician and top of engine.
3. Follow vehicle service manual
procedure to service timing belt
as required. Remove tool when
finished.
No. 6468 (511535)
Note: Same as Ford No. 303-398 (T92C-6256-AH).
511536 (6469) Ford Camshaft Sensor Synchronizer Tool
Application:
1997 3.8L V6 Cougar, Thunderbird
1997 – 2008 4.2L V6 Econoline, F-Series Truck
1996 – 1998 5.0L V8 Ford Explorer, Mercury Mountaineer
2004 – 2007 4.2L Freestar, Monterey
1996 – 1998 3.8L V6 Mustang, Windstar
CAUTION: Before removing the camshaft sensor housing
assembly, note the position of the camshaft sensor
electrical connector. To prevent equipment damage, the
connector MUST be reassembled in the same position
during installation.
1. Rotate crankshaft to set No. 1 cylinder at top dead center of
the compression stroke.
2. Engage camshaft sensor housing vane in slot of tool No.
511536 (6469).
3. Rotate tool on camshaft sensor housing until tool engages
housing notch. (Tool should be square and in contact with
entire top of housing.)
4. Install camshaft sensor housing and tool assembly into engine
according to instructions in the vehicle service manual. Torque
fasteners to factory specifications.
Camshaft
Sensor
Housing
No. 511536
(6469)
Note: Same as Ford No. 303-562 (T96T-12200-A).
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
