511543 / 511544 (6476) Ford Camshaft Positioning Tool Set
Application: 1997 – 2002 4.6L Econoline, F-Series Truck (VIN W)
1997 – 2002 5.4L Econoline, Expedition, F-Series Truck
1997 – 2002 6.8L V10 Econoline
1998 – 2002 5.4L Navigator
1.
Two-hole Camshaft Sprocket:
Use No. 511543 to position the camshaft sprocket (2-hole) on
the engine as shown.
18 mm Hex Hd. Camshaft Sprocket:
Use No. 511543 with No. 511544 to position the camshaft
sprocket (18 mm hex hd.) on the engine as shown.
2. Service the timing chain as required according to procedures
in the vehicle service manual.
3. Torque the fasteners to factory specifications.
511545 (6477) Ford Camshaft Holding Tool
Application: 1997 – 2009 4.6L Econoline, F-Series Truck (VIN W)
1997 – 2002 5.4L Econoline (V8), Expedition, F-Series Truck
1997 – 2002 6.8L V10 Econoline
1998 – 2002 5.4L V8 Navigator
1. Install tool No. 511545 (6477) on the camshaft as
shown.
2. Torque hex hd. bolts at 20 ft.•lbs. to ensure correct
clamping force. Note: Each bolt must be engaged
by the same number of threads in the bottom
clamp to ensure correct clamp alignment.
3. Repair the engine as required according to
instructions in the vehicle service manual.
No. 6477
(511545)
Note:
• Same as Ford No. 303-557 (T96T-6256-B).
• This tool is used with No. 6476 (511543 & 511544)
Ford Camshaft Positioning Tool Set.
511543 511544
No. 511543
No. 511544
18 mm
Hex Hd.
Camshaft
Sprocket
2-Hole
Camshaft
Sprocket
No. 511543
Note:
• 511543 is the same as Ford No. 303-569
(T96T-6256-AR1) and 511544 is the same
as Ford No. 303-570 (T96T-6256-AR2).
• This tool is used with No. 6477 (511545)
Ford Camshaft Holding Tool.
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
