![background image](http://html1.mh-extra.com/html/oster/078059/078059_instruction-manual_1657214003.webp)
English-2
BLADE REPLACEMENT: Unplug the clipper or trimmer from electrical outlet before blade
removal or replacement.
TO REMOVE:
1.
Remove the two blade mounting screws from clipper or trimmer. (Figure 1)
2.
Pull blade set forward and remove. (Figure 2)
TO REPLACE:
1.
Place new blade set into position on clipper or trimmer head. Position blade set to align
screw holes to blade and housing. (Figure 3-4)
2.
Tighten screws until snug, but not tight. (Figure 5)
3.
Be certain blade set is straight and centered. Tighten screws firmly. (Figure 5)
FOR MODELS WITH T-BLADE ONLY
TO ATTACH:
1.
Get front edge of blade started in comb track. (Figure 6)
2.
Press palm of hand against comb and push comb onto blade. If there is resistance, place on drop of oil on
inner side of comb.
Use caution when pressing hand against comb. Use cloth pad in palm if necessary.
REMOVING OR REPLACING BLADES
ATTACHING GUIDE COMBS
6
7
6
7
6
7
6
7
6
7
6
7
6
7
Waste Disposal
This marking indicates that this product should not be disposed with other household waste throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
When using or cleaning this clipper, do not use any non Oster™ approved aerosol sprays or blade
washes, especially those containing methylene chloride, dimethyl benzyl ammonium chloride, or 1-1-1
trichloroethylene.Damage caused by these chemicals will void your warranty. You may use Oster brand
cleaner and lube oil, which do not harm the product.
SERVICE INFORMATION
How and Where to Get Service
INFORMATION • DO NOT DESTROY • READ CAREFULLY
The foundation of our business has been built upon the principle of service to the user, both in designing superior products and in keeping
them in condition to give long-lasting use. That is why we back up our reputation for manufacturing top-quality products by providing the
finest service facilities possible for adjustment and repairs, when necessary. Please retain the original packaging materials and carton, if
possible, to facilitate the packaging of the product if service is required.
WARNING
To maintain longer blade life, Oster recommends periodic cleaning and oiling, using Oster brand blade wash and lubricating oil.
Position the blade in a flat dish filled with just enough Blade Wash to cover only the blade. Turn on the clipper or trimmer and listen for change in the
hum of the motor. As the build-up is removed, the clean blade runs faster and at a higher pitch. When the pitch stabilizes (30 to 60 seconds), turn off the
clipper or trimmer and unplug. Use a lint-free cloth to wipe blade as dry as possible. Oil blades.
Carefully slide upper blade left or right far enough to place ONE drop of oil on each running rail of the lower blade. EXCESS OILING WILL CAUSE HAIR TO
STICK BETWEEN TEETH, SLOWING OR JAMMING BLADES. While in use, spray Oster brand lubricant through blade teeth while the trimmer is running.
BLADE MAINTENANCE
BLADE CLEANING
BLADE OILING
Like fine cutlery, the blades of this clipper or trimmer may become dull with extended use. Sharpening demands special skill and equipment. FOR
GENUINE FACTORY SHARPENING, send your blades to Oster Direct
SM
or to an authorized service center near you.
BLADE SHARPENING
078059_17MLM1.indd 3
4/17/17 15:06