Oshkosh Corporation JLG R2632, Руководство по эксплуатации и безопасности

Страница: 13 / 108

SECTION 1 - SAFETY PRECAUTIONS
31215932
1-3
1.3 OPERATION
General
• Machine operation requires your full attention. Bring the machine
to a full stop before using any device, i.e. cell phones, two-way
radios, etc. that will distract your attention from safely operating
the machine.
• Do not use the machine for any purpose other than positioning
personnel, their tools, and equipment.
• Before operation, the user must be familiar with the machine
capabilities and operating characteristics of all functions.
• Never operate a malfunctioning machine. If a malfunction occurs,
shut down the machine. Remove the unit from service and notify
the proper authorities.
•
Do not remove, modify, or disable any safety devices.
• Never slam a control switch or lever through neutral to an oppo -
site direction. Always return switch to neutral and stop before
moving the switch to the next function. Operate controls with
slow and even pressure.
• Do not allow personnel to tamper with or operate the machine
from the ground with personnel in the platform, except in an
emergency.
•
Do not carry materials directly on platform railing unless approved
by JLG.
•
When two or more persons are in the platform, the operator shall
be responsible for all machine operations.
•
Always ensure that power tools are properly stowed and never left
hanging by their cord from the platform work area.
•
Do not assist a stuck or disabled machine by pushing or pulling
except by pulling at the chassis tie-down lugs.
•
Fully lower platform and shut off all power before leaving
machine.
•
Remove all rings, watches, and jewelry when operating machine.
Do not wear loose fitting clothing or long hair unrestrained which
may become caught or entangled in equipment.
• Persons under the influence of drugs or alcohol or who are subject
to seizures, dizziness or loss of physical control must not operate
this machine.
•
Hydraulic cylinders are subject to thermal expansion and contrac -
tion. This may result in changes to the platform position while the
machine is stationary. Factors affecting thermal movement can
include the length of time the machine will remain stationary,
hydraulic oil temperature, ambient air temperature and platform
position.