Oshkosh Corporation JLG E600, Руководство по эксплуатации и безопасности

Страница: 94 / 102

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-14 – JLG Lift – 3121217
by JLG. Due to size variations between tire brands, both tires
on the same axle should be the same.
Wheel Replacement
The rims installed on each product model have been designed
for stability requirements which consist of track width, tire pres-
sure, and load capacity. Size changes such as rim width, center
piece location, larger or smaller diameter, etc., without written
factory recommendations, may result in an unsafe condition
regarding stability.
Wheel Installation
It is extremely important to apply and maintain proper wheel
mounting torque.
WHEEL NUTS MUST BE INSTALLED AND MAINTAINED AT THE PROPER
TORQUE TO PREVENT LOOSE WHEELS, BROKEN STUDS, AND POSSI-
BLE DANGEROUS SEPARATION OF WHEEL FROM THE AXLE. BE SURE
TO USE ONLY THE NUTS MATCHED TO THE CONE ANGLE OF THE
WHEEL.
Tighten the lug nuts to the proper torque to prevent wheels from
coming loose. Use a torque wrench to tighten the fasteners. If
you do not have a torque wrench, tighten the fasteners with a
lug wrench, then immediately have a service garage or dealer
tighten the lug nuts to the proper torque. Over-tightening will
result in breaking the studs or permanently deforming the
mounting stud holes in the wheels. The proper procedure for
attaching wheels is as follows:
1. Start all nuts by hand to prevent cross threading. DO
NOT use a lubricant on threads or nuts.
2. Tighten nuts in the following sequence:
www. duma -rent.com