ORTEC digiBASE-E, Руководство пользователя

Страница: 58 / 72

digiBASE-E ™ High-Performance Power-over-Ethernet Multichannel Analyzer / PMT Base for Scintillation Detectors
52
SHOW_GATE
Reports the current setting for the GATE (Enable) Input. The digiBASE-E gate modes are
discussed in Section 2.2. See also SET_GATE and LIST_GATE.
Example Responses:
$F0None<CR>
Gate disabled.
$F1AcqCntrol<CR>
$F2AcqTrigger<CR>
$F3CoincGate<CR>
$F4EventCounter<CR>
$F5Routing<CR>
$F6Sync<CR>
$F7SyncMaster<CR>
SHOW_HV
Reports the current high voltage and the status of the high voltage power supply in the form
$Dvvvvvsssssccc <CR>
Where vvvvv represents the current output voltage if the high voltage is enabled, or the rear-
panel high voltage setting if the high voltage is disabled. sssss represents the status of the
high voltage bias supply as a 16-bit decimal number with the following bit definitions:
Bit 0 (LSB):
Bias supply polarity (0=positive, 1=negative).
Bit 1: Bias supply overload (0=overload, 1=normal).
Bit 2: High voltage enabled (0=disabled, 1=enabled).
Example Responses:
$D0100000003077<CR>
1000 V, negative, not overloaded, disabled.
$D0100000002076<CR> 1000 V, positive, not overloaded, disabled.
$D0100000007082<CR> 1000 V, negative, not overloaded, enabled.
SHOW_HV_ACTUAL
Returns the value of HV actually on the detector.
SHOW_HV_POLARITY
This returns the HV polarity setting as a $F record (always positive for the digiBASE-E).
Response:
$IPOS<CR>
The HV is positive.
SHOW_HV_TARGET
Under normal operation, the HV will go to this value when the HV is enabled. Reports the
current HV setting (see SET_HV) and the status of the HV power supply in the form:
$Dvvvvvsssssccc<CR>
where vvvvv represents the HV setting, and sssss represents the status of the HV bias supply
as a 16-bit decimal number with the following bit definitions: