Installation
18
When a mounting plate with cutout is used
This figure shows the
DGM60-ARAK
.
Screws (M4)
Spring washers
Positioning pin holes
(2 places)
Mounting holes
(2 places)
Positioning pins
When the positioning pin holes are used as mounting holes
Motor
Positioning pin holes
(2 places)
Screw hole machining
in a mounting plate
Screw hole machining
in a mounting plate
When installing from below the mounting plate
Use the positioning pin holes as mounting holes.
Fit the pilot of the actuator into the flange pilot having performed through-hole machining, and secure the mounting
holes with screws (four pieces). Provide screw hole machining in the mounting plate since the positioning pin holes
and the mounting holes are through holes.
This figure shows the
DGM60-ARAK
.
Screw hole machining
in a mounting plate
Screws (M4)
Spring washers
Positioning pin holes (2 places)
Use as mounting holes.
Mounting holes
(2 places)
Flange pilot
Pilot
When a mounting plate with through-hole is used
z
Design for mounting plate [reference] [unit: mm (in.)]
50 (1.97)
2×M4
70.71±0.03
(2.7839±0.0012)
33 (1.3)
ø45
(ø1.77)
46 (1.81)
30 (1.18)
50 (1.97)
[R16.5
(0.65)]
ø5 (
) × deep 3
+0.012
0
) × deep 0.12]
[ø0.1969 (
+0.0005
0
5 (
) × deep 3
+0.012
0
) × deep 0.12]
[0.1969 (
+0.0005
0
A
Details of section A (2:1)
6 (0.24)
