Oriental motor BX2 Driver Edition Series, Руководство по эксплуатации

Страница: 4 / 28

4
Safety precautions
CAUTION
•
Do not use the motor, gearhead, driver, or regeneration resistor in a state where the specification value is exceeded. Doing
so may result in fire, electric shock, injury, or damage to equipment.
• Do not insert an object into the openings in the driver. Doing so may result in fire, electrical shock, or injury.
• Do not touch the motor, gearhead, driver, or regeneration resistor while operating or for a certain time after stopping. The
surface of the motor, gearhead, driver, or regeneration resistor may be hot, thereby causing a skin burn(s).
• Do not leave anything around the motor and driver that would obstruct ventilation. Doing so may result in damage to
equipment.
• Do not touch the rotating part (output shaft) while operating the motor. Doing so may result in injury.
• Securely install the motor, gearhead and driver to their respective mounting plates. Inappropriate installation may cause
the motor, gearhead or driver to detach and fall, resulting in injury or damage to equipment.
• For the power supply of I/O signals, use a DC power supply with reinforced insulation on its primary and secondary sides.
Failure to do so may result in electric shock.
• Provide an emergency stop device or emergency stop circuit external to the equipment so that the entire equipment will
operate safely in the event of a system failure or malfunction. Failure to do so may cause injury.
• Immediately when a problem occurred, stop operation and turn off the driver power. Failure to do so may result in fire,
electrical shock, or injury.
• The motor surface temperature may exceed 70°C (158°F) even under normal operating conditions. If the
operator is allowed to approach the motor in operation, attach a warning label in a conspicuous position
as shown in the figure. Failure to do so may result in a skin burn(s).
Warning label
• Always use an insulated screwdriver to set the switches on the driver. Failure to do so may result in electric shock.
„ „
Warning information
A warning label with handling instructions is attached on
the driver.
Be sure to observe the instructions on the label when
handling the driver.
Driver side face