Orban Optimod-PC 1101, Руководство по эксплуатации

Страница: 180 / 258

3-60
OPERATION ORBAN MODEL 1101
setting of the
DJ B
ASS
boost control (in the Equalization screen). Thus, without in-
troducing obvious coloration, the gating smoothly preserves the average overall
frequency response “tilt” of the five-band compressor, broadly maintaining the “au-
tomatic equalization” curve it generates for a given piece of program material.
If the
MB GATE
control is turned
O
FF
, the
DJ B
ASS
control (in the Equaliza-
tion screen) is disabled.
MB Downward Expander (“Multiband Downward Expander Threshold”) deter-
mines the level below which the single-ended noise reduction system’s downward
expander begins to decrease system gain and below which the high frequencies be-
gin to become low-pass filtered to reduce perceived noise. There are two controls:
the
MB D
OWN
E
XPANDER
control sets the expansion threshold in Bands 1-4, while the
B5 D
OWN
E
XPANDER
control sets the expansion threshold in Band 5. Activate the sin-
gle-ended dynamic noise reduction by setting these controls to a setting other than
O
FF
.
The single-ended noise reduction system combines a broadband downward ex-
pander with a program-dependent low-pass filter. These functions are achieved by
causing extra gain reduction in the multiband compressor. You can see the effect of
this extra gain reduction on the gain reduction meters.
Ordinarily, the gating on the AGC and multiband limiter will prevent objectionable
build-up of noise and you will want to use the single-ended noise reduction only on
unusually noisy program material. Modern commercial recordings will almost never
need it. We expect that its main use will be in talk-oriented programming, including
sports.
Please note that it is impossible to design such a system to handle all program mate-
rial without audible side effects. You will get best results if you set the
MB D
OWN
E
XPANDER
control of the noise reduction system to complement the program mate-
rial you are processing. The
MB D
OWN
E
XPANDER
should be set higher when the input
is noisy and lower when the input is relatively quiet. The best way to adjust the
MB
D
OWN
E
XPANDER
control is to start with the control set very high. Reduce the control
setting while watching the gain reduction meters. Eventually, you will see the gain
increase in sync with the program. Go further until you begin to hear noise modula-
tion—a puffing or breathing sound (the input noise) in sync with the input program
material. Set the
MB D
OWN
E
XPANDER
control higher until you can no longer hear the
noise modulation. This is the best setting.
Obviously, the correct setting will be different for a sporting event than for classical
music. It may be wise to define several presets with different settings of the
MB
D
OWN
E
XPANDER
control and to recall the preset that complements the program ma-
terial of the moment.
Note also that it is virtually impossible to achieve undetectable dynamic noise reduc-
tion of program material that is extremely noisy to begin with, because the program
never masks the noise. It is probably wiser to defeat the dynamic noise reduction
with this sort of material (traffic reports from helicopters and the like) to avoid ob-
jectionable side effects. You must let your ears guide you.