OPTIMOD-PC
INSTALLATION
2-49
When I Launch the OPTIMOD-PC control application, the meters do not move and I
cannot control my card.
•
Unless you have only one OPTIMOD-PC card installed in your computer, you must
connect the application to a given card (via the
C
ONNECT
Menu item) before you
can control it. This is because the Control Application is designed to address more
than one card in multi-card installations. See the steps starting with step 4 on
page 2-5.
I can’t connect to a given OPTIMOD-PC card from my network.
•
You must check the
A
LLOW
N
ETWORK
T
O
A
CCESS
L
OCAL
C
ARDS
box in the
C
ARDS
A
ND
S
ECURITY
A
DMINISTRATION
dialog box for that card.
Other possible causes are:
•
Your computer’s firewall is blocking the connection. See page 2-58.
•
Password is wrong.
•
The target card is open on another computer on the network.
•
The system that houses the target card is not on.
•
The Orban Windows service routine,
OptimodPcService
, is not running in the
computer housing the target card.
•
The Orban Windows service routine has malfunctioned. If all else fails, try end-
ing and then restarting
OptimodPcService
in the Windows Task Manager:
A)
On the computer, navigate to
S
TART
>
S
ETTINGS
>
C
ONTROL
P
ANEL
>
A
DMINISTRATIVE
T
OOLS
>
S
ERVICES
.
B)
Locate
Orban Optimod 1101
in the list of services. Right-click it and select
S
TOP
.
C)
Right-click
OptimodPcService
and choose “Start.”
Shortly after powering-up your computer and opening the Optimod-PC 1101 applica-
tion, a message appears saying that the OptimodPC Service has stopped.
•
If you upgraded the software and you did not install it into the same location as
your previous software, the OPTIMOD-PC service was not overwritten correctly.
In this scenario, the OPTIMOD-PC service will not be started automatically and
the active parameters will not be restored until the OPTIMOD-PC Control appli-
cation is launched. You should uninstall any previous version of the OPTIMOD-
PC software via Windows Add/Remove Programs and re-install the new soft-
ware. See
Uninstalling the OPTIMOD-PC Software
I get clicks when I source my WAVE material from a CD.
•
CD audio playback can sometimes have dropouts if the CD player is being ac-
cessed by the IDE controller using PIO mode. Usually, this can be fixed by setting
the IDE controller to DMA mode. Here are the steps to change the setting on
Windows XP:
Содержание Optimod-PC 1101
