Orban OPTIMOD-FM 8600, Руководство по эксплуатации

Страница: 113 / 397

OPTIMOD-FM DIGITAL INSTALLATION
2-53
In the above table:
XXXXX
= the specified terminal port;
yyyyy
= the present terminal port in use.
Port 23 is the factory default.
Valid ports are defined according to existing standards. Any out-of-range or inva-
lid characters render the whole argument invalid.
8. To change the Modem Init string:
Applies only for modem connections (via 8600’s Serial 1 port)
Command Response
MO ATF0S0=4

MO[ATF0S0=4] entered

MO?
Using MO[ATF0S0=4]

The 8600 appends CR+LF to the modem init string as transmitted to a modem
(physically connected to Serial 1). The 8600 will not perform any case conversion
to the argument (i.e., lower case arguments will be transmitted to the modem as
lower case).
9. To change the Interface Type:
Command Response
TY M|D

(valid argument)
Ty: Modem|Direct entered

(invalid argument)
ERROR. Using Ty: Modem|Direct

TY?

Using Ty: Modem|Direct

10. To recall a preset:
Command Response
RP XXXXXXX[PASSCODE]
 (valid passcode and preset name)
ON AIR: XXXXXXX
(invalid passcode)
[no error message is issued]
In the above table:
XXXXXXX
= the preset name;
PASSCODE
= any valid passcode.
•
If a non-existent control value and/or an invalid passcode is entered, the 8600
will ignore the command. If a non-existent preset name is entered, your Optimod
will return an error message to indicate that the preset you entered does not ex-
ist.
•
You can apply this command anytime after the 8600 boots up. The 30-minute
timeout does not apply.