Orban OPTIMOD-FM 8600, Руководство по эксплуатации

Страница: 232 / 397

3-52
OPERATION ORBAN MODEL 8600
ample, turning down the
M
ULTIBAND
C
LIPPING
control by 2 dB and turning down the
P
EAK
L
IMITER
D
RIVE
by 3 dB reduces the drive level to the MX peak limiter by 5 dB
when the multiband compressors are producing a considerable amount of gain re-
duction. However, when the multiband compressors are producing little or no gain
reduction, the
MB L
IMIT
T
HR
control will have little or no effect. In our example, the
drive level to the MX peak limiter might be reduced by as little as 3 dB.
Another important difference between the
M
ULTIBAND
C
LIPPING
and
P
EAK
L
IMITER
D
RIVE
controls is that the
M
ULTIBAND
C
LIPPING
control setting is tracked by a hidden
M
ULTIBAND
C
LIPPING
control in the digital radio processing chain. Therefore, you can
adjust the
M
ULTIBAND
C
LIPPING
control in the FM chain without needing to reset the
HD L
IMITER
D
RIVE
control to ensure that the FM and HD channels are loudness-
matched. There is no such “hidden” HD control corresponding to the
P
EAK
L
IMITER
D
RIVE
control, so adjusting the
P
EAK
L
IMITER
D
RIVE
control requires you to manually
adjust the
HD L
IMITER
D
RIVE
control by the same amount to preserve the loudness
match in the two channels.
The Two-Band Structure
The Two-Band structure consists of a slow two-band gated AGC (Automatic Gain
Control) for gain riding, followed by an equalization section, a gated two-band
compressor, a high-frequency limiter, and a complex peak limiting system similar to
the one used in the Five-Band structure. The Two-Band structure can be used with
the MX-style peak limiter (to achieve highest performance) or with an 8500-style
peak limiter (to achieve lower delay). Like the “Two-Band Purist” structure in
Orban’s OPTIMOD-FM 8200, the 8600’s Two-Band Structure is phase-linear through-
out to maximize sonic transparency.
The Two-Band structure has an open, easy-to-listen-to sound that is similar to the
source material if the source material is of good quality. However, if the spectral
balance between the bass and high frequency energy of the program material is in-
correct, the Two-Band structure (when its Band Coupling 2 > 1 control is operated
toward 0%) can gently correct it without introducing obvious coloration.
The Two-Band structure is mainly useful for classical or “fine arts” programming that
demands high fidelity to the original program source.
Setting Up the Two-Band Structure for Classical Music
To set up the Two-Band structure, recall preset
CLASSICAL-2B, CLASSIC-2B MX,
CLASSICAL-2B+AGC,
or
CLASSIC-2B+AGC MX
presets.
These are the only two-band presets. To achieve the equivalent of an
8500
PROTECTION
preset, use the
CLASSICAL-2B
preset. To achieve
higher performance in protection applications, use the
CLASSIC-2B MX
preset instead.
Classical music is traditionally broadcast with a wide dynamic range. However, with
many recordings and live performances, the dynamic range is so great that the quiet
passages disappear into the noise on most car, portable, and table radios. Conse-
quently, the listener either hears nothing, or must turn up the volume control to