Opus OFC195C, Руководство пользователя, Страница: 29 / 48

26
17. Remove the four bed support legs. Insert the legs into the steel sub frame of the Camper with
the retained pull pin end towards the exterior of the Camper.
Use the D-pin and insert through the apertures on the steel frame and through the pin apertures
on the leg as well as through the retaining ring of the retained pin secure the leg onto the Camper
by hooking the D-wire over the pin.
18. Close the rear lid of the Camper first. Tuck in all excess (protruding) canvas as you go also
ensure the tent canvas doesn’t snag on the pole brackets or the tent housing runners.
19.
Close the front lid, again tuck in all excess canvas to ensure that no canvas is protruding from
either side or across the middle where the two lids meet. Also ensure no canvas is snagged on the
pole mechanism.
IMPORTANT! IT IS ESSENTIAL THAT NO TENT MATERIAL IS VISIBLE WHEN THE LIDS ARE
SECURED/CLOSED, AND THAT NO MATERIAL IS TOUCHING THE SEALS.
MIDDLE POLE FOLDED AND POSITIONED
ON TOP OF BASE CUSHIONS UNDO EXTERIOR BUNGEE CLEATS LIFT CANVAS OFF EACH CORNER
OF THE BED TRAYS
13. 15. 16.
REMOVE THE FOUR BED SUPPORT
LEGS D-PIN SECURES BED SUPPORTS
17. 17.1
CLOSE REAR LID OF CAMPER FIRST THEN CLOSE THE FRONT LID ENSURE MIDDLE SECTION OF
CAMPER IS CLEAR OF MATERIAL
18. 19. 19.1