Opus OFC195C, Руководство пользователя, Страница: 12 / 48

SETTING UP YOUR OPUS
®
CAMPER.
9
ENGAGE HANDBRAKE WIND DOWN CORNER STEADY CORNER STEADY DOWN
REMOVE THE D-PIN TO RELEASE LEG SECURE BASE OF LEG WITH D-PIN REST BED LEGS ON THE GROUND
1.
2.1
INITIAL STEPS
1.
Once you have positioned your OPUS ® in the desired location then you must engage the handbrake.
IMPORTANT! DO NOT ENTER THE OPUS
®
UNTIL THE CORNER STEADIES HAVE BEEN
LOWERED IN THE CORRECT POSITION.
2. Raise or lower the jockey wheel to level your OPUS ® lengthways. Using the included corner
steady winder (or cordless drill/driver with a 19mm hex socket attachment) wind down each
corner steady leg until it touches the ground. Depending on the terrain, you may need to adjust
each corner to level the OPUS
® widthways. KoPads (corner steady feet) are available as an
accessory that clip onto the base of each corner steady to spread the load of the leg and enable
a sure footing, reducing the risk of sinking into softer ground.
3.
Once satisfied that the OPUS ® is stable and level, you need to fit the four bed tray support legs.
The legs are interchangeable and any leg can be fitted to any of the brackets. The legs are stored
in each corner within the steel frame and are accessible by unclipping the D-pin clip and sliding
them out.
Each leg has a retained pull pin on one end; the end without the pull pin should be inserted into
the lower bracket on the frame of the Camper. The D-pin is then used to secure the leg onto the
bracket. Insert the pin through the bracket and leg holes and secure it with the clip. For the
moment the other end of the bed leg can rest on the ground. Repeat this procedure for the three
remaining legs.
4. If applicable unstrap your water and waste carriers and place them beneath the trailer near their
respective outlets. Also, access the gas locker and turn on the gas bottle if applicable.
2.2
3 3.1 3.2