Opus OFC195C, Руководство пользователя, Страница: 18 / 48

15
IMPORTANT: THE 12v SOCKET LOCATED INSIDE THIS UNIT ONLY POWERS THE FRIDGE
WHEN IN TRANSIT IF THE TOW VEHICLE IS UTILISING THE 13-PIN (OR TWIN 7-PIN) SOCKETS.
THIS 12v SOCKET IS ONLY POWERED WHILST THE TOW VEHICLE’S ENGINE IS RUNNING
AND DOES NOT OPERATE OR PROVIDE POWER WHEN THE CAMPER IS DISCONNECTED
FROM A RUNNING VEHICLE AND IS ONLY FOR USE AS A FRIDGE SOCKET.
CLUB LOUNGE ASSEMBLY
1. Place the table out of the way to start with - this can be left on either bed.
2.
Locate all seat cushions, and then locate the Velcro fitted to each one to help you understand
where each cushion goes. (Two of the cushions will be located in the middle cupboard in the
OPUS
® rear seating section. Cushion numbers 4 & 8 as shown in the diagram opposite.)
3. The three seat bases are already in position - cushion numbers 1,2 & 3, fit the seat back with
the Velcro on both sides into the void of the long seat base - cushion number 6.
4.
The corner cushions can now be positioned and attached to the rear seat back with the Velcro
- cushion numbers 5 & 7.
5.
The other two seat backs should be placed at their respective sides with the Velcro sides facing
towards the rest of the cushions (rear of the Camper) and attached to the corner cushions.
Cushion numbers 4 & 8 from the middle cupboard.
6. Fit the table leg into the aperture located in the floor of the Camper.
7. Locate the table socket on the underside of the table and place it over the top of the table leg.
Firm pressure on the table centre will set the table and table leg securely for use.
The main set-up of the Camper is now complete. The water, gas and electric systems sections
detail the use and function of the individual components.
CLUB LOUNGE/SEATING AREA PACKED DOWN