34
Count –
counter of gildings/stampings made since the device has been switched on.
The counter counts only complete gilding/stamping cycles (raising of the lever before
the matrix moves to the stamping position will not trigger the counter). The counter
may operate in the increment mode or decrement mode.
In the increment mode the counter after each stamping cycle increases its value, in
the decrement mode it decreases its value. In the decrement mode the counter
should be initially set to the value from which it is to start counting cycles down to
0. After reaching 0, the controller indicates that with a long beep.
To set the counter press the Count button and then select the up/down option,
within 2 seconds set the value using the [ ] and [ ] buttons (the initial value can
be set in both the increment and decrement mode).
Prog -
number of the current program. mrogram is a set of the most used
gilding/stamping settings. Program numbers range from 0 to 9.
To define the set of settings, press the Count/Prog [ ] button briefly to open the
program selection menu (”set prog” blinks) and then, within 2 seconds, select the
appropriate program number P0-P9 using the Count/Prog [ ] or [ ] buttons. The
program selection is confirmed if no button is pressed within 2 seconds. Now every
change in the settings is saved to the selected program.
If no button is pressed for a few seconds, changes are saved to the memory and the
main menu is displayed.
In addition, messages informing about the status of the device are displayed in the
first cell of the right column:
Ready –
indicates that the device is ready to run: the message appears when the
temperature of the heater reaches the set temperature range (set temperature ±3°).
Additionally, every time the heater temperature reaches the set value, a single beep
is given.
Limit Top –
slider moved to extreme top position
Limit Bot –
slider moved to extreme bottom position
Run –
electrical drive of the slider started
Over Temp –
permissible heater temperature exceeded
Heater Off -
heater turned off
Note
A dot displayed in the bottom right corner indicates that the heater is energized.
Note
The units in which temperature is displayed (Celsius / Fahrenheit) can be changed
immediately after switching on before the main menu is displayed. To change the
temperature unit, when switching on the device press and hold the Temp [ ] button
to set Celsius, or the Temp [ ] button to set Fahrenheit.
Содержание MasterPress 02
Страница 6: ...4 OPIS URZ DZENIA I AKCESORIA 6...
Страница 22: ...22...