optris PI 400 LW, Руководство оператора

Страница: 30 / 52

optris PI LightWeight Kit
– E2013-04-B
28
The used Ethernet cables should be
at least category 5 cables (Cat-5
according ISO/IEC 11801).
Ethernet Direct Communication
Please connect your imager with the supplied USB connection cable with the NetBox. Please connect your
PC with an Ethernet cable with the NetBox. Now connect the power supply to the NetBox and to the mains.
The NetBox will start to boot the system and should be ready to use after 2-3 minutes.
You can check the status with the LEDs. At proper functioning now L1 and L5 should light up.
Ethernet direct connection (point-to-point connection)/ NetBox LW powered via power supply
If you use a PoE injector the power supply for the NetBox is not needed. In this case please connect the PoE
injector as shown in the drawing below. At proper functioning now L1, L2 and L5 should light up.