OPTOTRONIX SkyFire LCU, Руководство пользователя

Страница: 15 / 20

15
Step 3 ‐ Programming the pause time
In this step, all outputs and orange Status LEDs light up as they were programmed in
advance. By pressing ("zapping") the set button the pause time between the flash
sequences can now be changed in 5 steps, so that the flash sequences can be individually
optimized for each model aircraft.
By pressing the Set ‐ button for short you can zap through the pause ‐ time options. The
MODE LED flashes quickly Orange at different rates in order to illustrate the speed. Save the
desired pause time by pressing the Set button for 2 seconds.
Step 4 ‐ Programming the AUX output
The orange Status LED No. 10 " AUX" lights up and waits for programming the activation
point and light function. Proceed exactly the same way as in the programming of the 9 light
channels.
In contrast to the 9 light channels, the AUX output offers long ‐ term operation (on / off
operation) or 9 different afterburner simulations.
The following functions are available in the AUX output of the SkyFire LCU :
Nr. Function
0 On / Off Operation (switching external loads)
1
Afterburner Effect – random flickering – without dimming up
2
Afterburner Effect – random flickering – slowly dimming up
3
Afterburner Effect – random flickering – fast dimming up
4
Afterburner Effect – random flickering – very fast dimming up
5
Afterburner Effect – random flickering – backfire and slowly dimming up
6
Afterburner Effect – random flickering – backfire and fast dimming up
7
Afterburner Effect – random flickering – multiple backfires
8
Afterburner Effect – random flickering – slowly dimming up in 2 phases
9
Afterburner Effect – random flickering – fast dimming up in 2 phases
10
Afterburner Effect – proportional dimming to the throttle – Backfire and flickering
If the programming of the AUX output is complete, the changes are saved immediately. If
otherwise no changes should be made, you do not need to go through the further
programming mode. Turn the SkyFire LCU off and on again.
Step 5 ‐ Programming the reception ‐ quality monitoring
In this step, the monitoring of the reception quality (RQO) is activated and programmed. The
orange Status LEDs in the middle light up above the antenna the remaining status LEDs
display "emitting radio waves" in order to illustrate the RQO programming. The MODE ‐ LED
lights up continuously blue (Display of the RQO ‐ mode).