OPTOTRONIX SkyFire LCU, Руководство пользователя

Страница: 10 / 20

10
Battery test
The battery test function can be started at any time by briefly pressing the Set button .
During the battery test (about 3 seconds) the connected model lighting is disabled. The
following behaviour is seen:
Traffic light sequence
The MODE LED changes for 3 seconds
between colours green ‐ Orange ‐ red . This
illustrates the actual battery test ("charging ‐
status traffic light effect")
Displaying charging status
Using the 10 orange Status LEDs the battery
charge ‐ status is displayed. The scale of state
of charge is used for illustration:
The voltage of the battery can be read through the 10 orange Status LEDs of SkyFire LCU. If
all 10 LEDs light up, the battery is fully charged (charge ‐ status scale: 100%).
The MODE LED jumps to green if the state of charge is > 40%, to Orange if the state of
charge is <40%.
If the battery voltage falls under a critical threshold voltage for several seconds (depending
on the connected and programmed battery type), the SkyFire LCU turns off completely, in
order to avoid a deep discharge of the battery and thus to prevent damage and can only be
put back into operation by pressing again the power button .
Check reception quality
If the monitoring of the reception quality ( R eception Q uality O bservation, RQO) was
activated and programmed, the SkyFire LCU permanently monitors the signals of the
receiver and warns of reception problems.
Press the Set button . After the battery test function (MODE LED shows traffic light
sequence green ‐ Orange ‐ red ) the reception quality is displayed (MODE LED will light blue ).
The following behavior must be seen after displaying charge ‐ status:
Scan ‐ Sequence
The MODE LED lights up blue now. A blue
lighting generally shows that reception data is
displayed now.
The orange Status LEDs in the middle light up
above the antenna icon, the remaining status
LEDs display "emitting radio waves" in order
to clarify that the RQO status is showed.